Pella 808F0105 User Manual download pdf

REMEMBER TO USE APPROPRIATE PERSONAL PROTECTIVE EQUIPMENT.

INSTALLATION INSTRUCTION -

INSTRUCCIONES DE INSTALACION

PELLA

PRECISION FIT AND RENOVATION POCKET

REPLACEMENT DOUBLE-HUNG VENT WINDOW

Always read the Pella® Limited Warranty before purchasing or installing Pella

products. By installing this product, you are acknowledging that this Limited Warranty

is part of the terms of the sale. Failure to comply with all Pella installation and maintenance

instructions may void your Pella product warranty. See Limited Warranty for complete details at

http://warranty.pella.com.

INTERIOR

Flashing tape

Checkrail

YOU WILL NEED TO SUPPLY: TOOLS REQUIRED:

• Cedar or Impervious shims/spacers (12 to 20)

• Closed cell foam backer rod/sealant backer (12 to 30

ft.)

• Pella

SmartFlash

™

foil backed butyl window

and door ﬂashing tape or equivalent

• High quality exterior grade polyurethane or silicone

sealant (1 tube per window)

• Great Stuff ™ Window and Door Insulating Foam

Sealant by the Dow Chemical Company or equivalent

low pressure polyurethane window and door foam -

DO NOT use high pressure or latex foams.

• Tape measure

• Level

• Hammer

• Utility knife

• Pry bar

• Sealant gun

• Screwdrivers

(#2 Phillips and Flat blade)

• Putty knife

• Wood chisel

• Drill

Installation will require two or more persons for safety reasons.

SEALANTSEALANT

Important! The Pella Replacement Window is designed to replace older style double-hung

windows. The original window frame will remain in place and only the existing sash will be

removed. Read these instructions thoroughly before beginning. Failure to install as recommended

will void any warranty, express or implied. For types of installation other than shown, contact your

local Pella representative or visit http://www.pella.com.

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - INSTRUCCIONES DE INSTALACION

Page 2 - DOUBLE-HUNG SASH REMOVAL

Interiorsash stopExteriorblind stopPartingstopBottomsashStoolSillApronTop sashBottomsash weightTop balancecordBalancecord pulleysTop sashweightBottomb

Page 3 - PREPARE THE OPENING

D. Lower the top sash and cut the balance cords allowing the balance weights to fall into the weight pocket. Remove the top sash.E. Remove the balan

Page 4

3CA. Apply a 3/8" continuous bead of sealant to the interior face of the existing blind stops at the head and both jambs.B. Place a bead of sea

Page 5 - EXTERIOR

3F F. Place shims approximately 5" up from the bottom of window to plumb and square the window. Check for squareness by making sure the diagonal

Page 6 - EXTERIOR SEAL

Caution: Ensure use of low pressure polyurethane window and door insulating foams and strictly follow the foam manufacturer’s recommendations for appl

Page 7 - INTERIOR FINISH

EXTERIOR FINISHThe exterior frame and sash are protected by aluminum cladding with our tough EnduraClad® or EnduraClad Plus baked-on factory nish tha

Page 8 - IMPORTANT NOTICE

CARE AND MAINTENANCECare and maintenance information is available in the Pella Owner’s Manual. You can obtain an owner’s manual by contacting your loc

Comments to this Manuals

No comments

Pella 808F0105 User Manual

Browse online or download User Manual for For Home Pella 808F0105. Pella 808F0105 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For Home Pella 808F0105