Pella 818K0100 User Manual download pdf (Page 3)

A. Conﬁ rm the opening is plumb and level.

Note: It is critical that the bottom is level.

B. Conﬁ rm the door will ﬁ t the opening. Measure

all four sides of the opening to make sure it is 3/4"

larger than the door in width and 1/2" larger in height.

Measure the width at the top, bottom, and center.

Measure the height at the far left side, the far right

side, and in the center.

Note: 1-1/2" or more of solid wood blocking is

required around the perimeter of the opening.

Fix any problems with the rough opening before

proceeding.

C. Cut the water resistive barrier.

ROUGH OPENING PREPARATION

Interior

Exterior

UIDVU

.BLFBDVUVQGSPN

FBDIUPQDPSOFSBUB



BOHMFUPBMMPXUIFXBUFS

SFTJTUJWFCBSSJFSUPCFMBQQFE

PWFSUIFmOBUUIFIFBEPG

UIFEPPS

TUDVU

OEDVU

SEDVU

8BUFS3FTJTUJWF#BSSJFS

$

D. Fold the water resistive barrier. Fold side ﬂ aps into the

opening and staple to inside wall. Fold top ﬂ ap up and

temporarily fasten with ﬂ ashing tape.

For Doors Using Optional Sill Pan Go To Step 1I.

E. Apply sill ﬂ ashing tape #1. Cut a piece of ﬂ ashing tape 12"

longer than the opening width. Apply at the bottom of the

opening as shown (1E) so it overhangs 1" to the exterior.

Note: The tape is cut 12" longer than the width so that it

will extend 6" up each side of the opening.

F. Tab the sill ﬂ ashing tape and fold. Cut 1" wide tabs at

each corner (1/2" from each side of corner) (1F). Fold tape

to the exterior and press ﬁ rmly to adhere it to the water

resistive barrier.

G. Apply sill ﬂ ashing tape #2. Cut a piece of ﬂ ashing tape

12" longer than the opening width. Apply at the bottom,

overlapping tape #1 by at least 1". DO NOT allow the tape to

extend past the interior face of the framing (1G).

In-swing doors: If the wall depth is greater than 5", add a

third piece of ﬂ ashing tape. The ﬂ ashing tape should come to

within 1" of the interior face of the framing.

Note: The ﬂ ashing tape may not fully cover the

framing members.

1/2"



£

H. Attach the aluminum sill support or wood blocking to the

exterior of the box plate to support the edge of the door sill.

Place the sill support ﬂ ush with the subﬂ oor.

DOORS • ALL DOORS • ALL DOORS • ALL DOORS • ALL DOORS • ALL DOORS • ALL DOORS

GO TO STEP 2

1 2 3 4 5 6 7 8 ... 15 16

Comments to this Manuals

No comments

Pella 818K0100 User Manual Page 3

Comments to this Manuals

Related products and manuals for Toys & accessories Pella 818K0100