Pella 818K0100 User Manual download pdf (Page 2)

YOU WILL NEED TO SUPPLY: TOOLS REQUIRED:

• Cedar or Impervious shims/spacers (12 to 20)

• 16d galvanized ﬁ nish nails (1/4 lb.)

• #10 x 3-1/4" corrosion resistant wood screws

(Performance Upgrade and HurricaneShield)

• Masonry screws for concrete applications

(Minimum of 3/16" diameter x 3")

• Closed cell foam backer rod/sealant backer

(21 to 30 ft.)

• Pella

SmartFlash

™

foil backed butyl window and door

ﬂ ashing tape or equivalent

• High quality exterior grade polyurethane or silicone

sealant (2 to 3 tubes per door)

• Great Stuff

™

Window and Door Insulating Foam

Sealant by the Dow Chemical Company or equivalent

low pressure polyurethane window and door foam -

DO NOT use high pressure or latex foams

• Sill Pan (Optional)

6-5/8" x (Rough Opening Width + 2")

• Pella aluminum sill support or wood blocking

• Interior trim and/or jamb extensions (15 to 40 ft.)

• Aluminum Head Flashing

• Tape measure

• Level

• Square

• Hammer

• Stapler

• Sealant gun

• Scissors or utility knife

• Tin snips

• Screwdrivers (#2 Phillips with

8" shaft and small ﬂ at blade)

• T20 Torx Wrench

• Drill

• Drill bits 13/64" and 1/8"

and masonry bit for

concrete applications

INSTALLATION CLIP OPTION:

• 6" or 8" installation clips

• #6 x 5/8" corrosion resistant ﬂ at head wood screws

• #8 x 1-1/2" corrosion resistant screws or 3/16" x 1-1/2" masonry screw

SEALANT

The performance of any building is dependent upon the design, installation, and workmanship

of the entire building system. Pella Corporation strongly recommends consulting an

experienced architect, contractor, or structural engineer prior to installation of Pella products.

The individual (building owner, architect, contractor, installer and/or consumer) responsible

for the project must take into account local conditions, building codes, inherent component

limitations, the effects of aging and weathering on building components, and other design

issues relevant to each project.

The determination of the suitability of all building components for each project, as well as the

design and installation of ﬂ ashing and sealing systems, are the responsibility of the building

owner, architect, contractor, installer and/or consumer.

1 2 3 4 5 6 7 ... 15 16

Comments to this Manuals

No comments

Pella 818K0100 User Manual Page 2

Comments to this Manuals

Related products and manuals for Toys & accessories Pella 818K0100