Part Number: 818K0100©2011 Pella Corporation INSTALLATION INSTRUCTION - INSTRUCCIONES DE INSTALACIONWOOD HINGED PATIO DOOR – (INCLUDES – STANDARD, PER
6" 16" MAX O.C. 16" MAX O.C. 16" MAX O.C. 16" MAX O.C. 6" 6" 6" 6" 6" 6" 6" OUT-SWING
5FAP & HURRICANESHIELDPERFORMANCE UPGRADE & HURRICANESHIELD DOORS • PERFORMANCE UPGRADE & D. Secure the jambs and head of the door. Drive
7SEALING THE DOOR TO THE EXTERIOR WALL CLADDINGWhen applying siding, brick veneer or other exterior fi nish material, leave adequate space between the
INTERIOR FINISHINGIf products cannot be fi nished immediately, cover with clear plastic to protect from dirt, damage and moisture. Remove any construct
TROUBLESHOOTING - Adjustable Strike Latching Issues5"#4"EKVTUBCMFTUSJLFTIJNTJEFWJFX4USJLFGSPOUWJFX"EK4USJLF4IJNFOEWJFX&ap
This page left blank intentionally.
This page left blank intentionally.
YOU WILL NEED TO SUPPLY: TOOLS REQUIRED:• Cedar or Impervious shims/spacers (12 to 20)• 16d galvanized fi nish nails (1/4 lb.)• #10 x 3-1/4" corro
A. Confi rm the opening is plumb and level. Note: It is critical that the bottom is level.B. Confi rm the door will fi t the opening. Measure all four
L. Bend each end of the center panel up.J. Make a 1" cut in each fold at both ends of the sill pan.Note: These cuts will allow the edges of the
2PREPARE THE DOOR FOR INSTALLATIONTWO OR MORE PEOPLE WILL BE REQUIRED TO HANDLE THE PANEL AND FRAME SAFELY.A. Remove plastic wrap and cardboard packa
6“ from end Lip #6 x 5/8” corrosion resistant screws 2BALL DOORS • ALL DOORS • ALL DOORS • ALL DOORS3SETTING AND FASTENING THE DOORB. Cut and remove
Exterior 16d galvanizedfinishing nailsD. Plumb and square door. Place shims at each hinge and lock strike location between the door and the sides of t
of sealant into the three sill strike holes and install the three # 8 x 3" fl at head stainless steel screws (provided) into the holes. K. Shim
N. For Doors with adjustable hinges: The hinges can be used to move the panel side to side by moving all hinges in the same direction or the hinges c
Comments to this Manuals